JVC GY-DV550E Instruction Manual - Page 57

7-5 Recording External Video Signals 7. SHOOTING OPERATION PUSH VTR/RM DV CAMCORDER GY-DV550 PROMPTER OUTPUT Y/C OUT MONITOR OUT LINE OUT CH-1 CH-2 TC IN TC OUT REMOTE GENLOCK/AUX IN VIDEO OUT AUDIO IN FRONT LENS FILTER 1 3200k 2 5600k+1/8ND 3 5600k+1/64ND SHUTTER STATUS MENU ALARM MONITOR AUTO IRIS FULL AUTO BLACK BACK L NORMAL SPOT L STRETCH NORMAL COMPRESS LOLUX VTR GAIN OUTPUT WHT.BAL NG OPERATE ON OFF OPERATE/WARNING RESET MONITOR SELECT CH-1 MIX CH-2 LIGHT ON OFF COUNTER CTL TC UB CH-1 AUDIO CH-2 LEVEL CH-1 CH-2 AUTO MANUAL AUDIO SELECT CH-1 CH-2 FRONT REAR AUDIO INPUT MODE RM VTR INCOM MIC CARBON DYNAMIC INCOM MIC ON LEVEL OFF CALL RM OFF DC IN /BATT. POWER CH-1 AUDIO LEVEL SEE INSTRUCTION MANUAL LITHIUM BATT. CH-2 CH-1 CH-2 AUTO MANUAL AUDIO SELECT CH-1 CH-2 FRONT REAR AUDIO INPUT VTR SELECT TC GENE. CONTINUE INT PARA PRST REC FREE EXT REGEN MENU GROUP CAM AUX HOLD ITEM SELECT DATA SET SHIFT ADVANCE PRESET VTR INPUT VTR INPUT switch GENLOCK/AUX IN Other than camera images, composite video signals from an external device connected to the GENLOCK/AUX IN connector can also be recorded with this unit. When recording external video signals, perform the following connection and setting. Input the stabilized composite video signals to the GENLOCK/ AUX IN connector. Input level: 1V (P-P) ±0.3V (P-P) Set the VTR INPUT switch to AUX. Memo: • External video signals can only be recorded on the VCR of this unit. The VTR SELECT switch setting is ignored. External video signals will not be recorded on the external VCR connected to the VTR/RM connector. • During external video signal recording, recording check by pressing the RET button on the lens section cannot be performed. • When setting the VTR/RM switch to RM, external video signals will not be recorded even if the VTR INPUT switch is set AUX. The GENLOCK/AUX IN connector will function as a synchronous signal input connector. • The camera images will be outputted from the VIDEO OUT connector and VTR/RM multi-pin connector even when setting the VTR INPUT switch to AUX. For details concerning the output images when setting the VTR INPUT switch to AUX, see the following table. • Whether to add setup signals can be selected in SETUP item of the Camera SETUP menu screen. Output signals when setting the VTR INPUT switch to AUX Viewfinder MONITOR OUT Y/C OUT VIDEO VTR/RM OUT (26-pin) AUX (external) AUX (external) AUX (external) Camera Camera video video video images images About the status screen display of the viewfinder During external video signal recording, camera setting related information will not be displayed on the status screens. The displayed status screens are as follows: • Status screens 0 and 1 are displayed. Status screen 2 will not be displayed. • AUX will appear on the upper right of the screen. • INT will constantly appear in the VTR SELECT display. AUX indicator AUX STATUS button M : 09 9 1 2 . 4V Status screen 0 AUX INT indicator I NT STBY CH1 CH2 < 60 M : 09 9 1 2 . 4V Status screen 1 CAUTION: Do not change the VTR INPUT switch setting during recording. 57