JVC KW-V10 Instruction Manual - Page 50
Installing the unit
View all JVC KW-V10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
CONNECTION/INSTALLATION R Installation procedure 1 To prevent a short circuit, remove the key from the ignition and disconnect the · battery. 2 Make the proper input and output wire connections for each unit. 3 Connect the speaker wires of the wiring harness. 4 Connect the wiring harness wires in the following order: ground, battery, ignition. 5 Connect the wiring harness connector to the unit. 6 Install the unit in your car. 7 Reconnect the · battery. 8 Press the reset button. 9 Configure . (page 4) Installing the unit R Installing the unit (only for KW-V40BT Region 4/KW-V20BT Region 4/KW-V10 Region 4) R Installing the trim plate (only for KWV40BT Region 4/KW-V20BT Region 4/ KW-V10 Region 4) 1 Attach the trim plate (2). 2 • Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. R When installing the unit using the mounting bracket removed from the car 5 or 6 Car Bracket 5 or 6 • Select the appropriate type of screw for the mounting bracket: flat head (5) or round head (6). 50