Kyocera ECOSYS P8060cdn ECOSYS P8060cdn Operation Guide - Page 181

Operation on the Machine > Manual Staple 3 Load the paper. Straighten the edges of the paper well and place the paper front side down in the shutter opening of the output unit. B A If the near side of the paper ( ) will be stapled, place the paper against the front guide (A). If the far side of the paper ( ) will be stapled, place the paper against the back guide (B). If the edge of the paper ( ) will be stapled at two points, place the paper with the center aligned to the center point between the two side guides (A and B). CAUTION Do not insert your hand inside the open shutter. NOTE • Press the stapling position key before you place the paper. Once the paper is placed, the stapling position key cannot be used. • The stapling lamp lights when the paper is properly placed. If it does not light, replace the paper. 4 Staple the paper. Let go of the paper, and then press the stapling key. Stapling starts. Stapling finishes and the output is delivered to tray. CAUTION Be sure that your hands are away from the paper while stapling is in progress. Finishing the manual staple mode Press the stapling position key several times until the stapling position lamps turn off. The shutter of the paper exit area closes. It means that manual stapling is finished. If no operation is performed for approx. 10 seconds, the manual staple mode will be automatically finished. NOTE The time after which manual staple mode is automatically exited can be changed. Manual Staple (page 8-19) 5-31