Kyocera ECOSYS P8060cdn ECOSYS P8060cdn Operation Guide - Page 288

User Authentication and Accounting (User Login, Job Accounting) > Setting User Login Administration Obtain NW User Property Set the required information to obtain the network user property from the LDAP server. The user name and E-mail address obtained with this setting is shown in the user information, the status confirmation screen, and the header of E-mail. NOTE To obtain the network user property from the LDAP server, User Login Administration must be enabled in "Enabling User Login Administration". Select "On" for "LDAP" in "Protocol Detail". Enabling User Login Administration (page 9-3) Protocol Settings (page 8-38) 1 Display the screen. 1 [System Menu/Counter] key > [User Login/Job Accounting] NOTE If the login user name entry screen appears during operations, enter a login user name and password, and select [Login]. For this, you need to login with administrator privileges. The factory default login user name and login password are set as shown below. Login User Name: 6000 Login Password: 6000 2 [User Login Setting] > [Obtain NW User Property] > [On] 2 Configure the settings. [On] > Add information on each item > [OK] Item Server Name*1 Port Name 1*2 Name 2*3 E-mail Address*4 Authentic at Type*5 Descriptions Enter the LDAP server name or the IP address (up to 64 characters). If a server name is not entered, user information will be acquired from the server set for Network Authentication. Port number for LDAP server. The default port number is 389. Enter the LDAP Attribute to obtain the user name to be displayed from the LDAP server (up to 32 characters). Enter the LDAP Attribute to obtain the user name to be displayed from the LDAP server (up to 32 characters). Enter the LDAP Attribute to obtain the E-mail address from the LDAP server (up to 32 characters). Set the authentication method. Select [Simple] or [SASL]. After changing the setting, restart the system or turn the power off and then on. 9-13