Kyocera ECOSYS P8060cdn ECOSYS P8060cdn Operation Guide - Page 330

Troubleshooting > Troubleshooting Symptom Checkpoints Corrective Actions Reference Page Cannot print with USB memory. USB memory not recognized. Is the USB host blocked? ― Select [Unblock] in the USB host settings. Check that the USB memory is securely plugged into the machine. page 8-46 ― While "Auto-IP" is already set to [On], the IP address is not assigned automatically. Is a value other than "0.0.0.0" entered for the link local address of TCP/IP(v4)? Enter "0.0.0.0" for the IP address of TCP/IP(v4). page 2-25 Cannot connect to this machine by using Wi-Fi Direct. Are three handheld devices connected simultaneously? Release the connection of handheld devices being connected manually or set a connection after setting the connection time and releasing the connection by automatic disconnection. page 8-31 Cannot send via the e-mail. Is the E-mail send size limit set in the SMTP server registered on the machine? Check the limit value is entered to "E-mail Size Limit" of [E-mail] setting in Command Center RX and change the value as necessary. page 2-55 The machine is emitting Check the room temperature to see Depending on the printing ― steam in the area around if it is low, or if damp paper was environment and the paper's the paper ejection slot. used. condition, the heat generated during printing will cause the moisture in the paper to evaporate, and the steam emitted may look like smoke. This is not a problem, and you can continue printing. If the steam concerns you, raise the room temperature, or replace the paper with a newer, dryer paper. 10-19