Lexmark 4076 Execjet II Service Manual - Page 35
Encoder Sensor Test on, Maintenance Station Service, Check
View all Lexmark 4076 Execjet II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
4076-0XX FRU OR PROCEDURE 5 Print Head Cable 6 Encoder Strip Print Head Cable, System Board 7 Maintenance Station ACTION Be sure connector J1 is fully seated. Check the cable for damage. Perform the "Encoder Sensor Test" on page 27. If you cannot enter the test, replace the system board. A problem with the maintenance station can cause carrier movement problems at the right margin. Go to the "Maintenance Station Service Check" on page 12. Diagnostic Information 23
4076-0XX
Diagnostic Information
23
5
Print Head Cable
Be sure connector J1 is fully seated.
Check the cable for damage.
6
Encoder Strip
Print Head Cable,
System Board
Perform the
“Encoder Sensor Test” on
page 27
. If you cannot enter the test,
replace the system board.
7
Maintenance Station
A problem with the maintenance sta-
tion can cause carrier movement
problems at the right margin. Go to
the
“Maintenance Station Service
Check” on page 12
.
FRU OR PROCEDURE
ACTION