Netgear WN802Tv2 Reference Manual - Page 73
Configuring Repeater without Wireless Client Association
UPC - 606449058505
View all Netgear WN802Tv2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
NETGEAR Wireless-N Access Point WN802T v2 Reference Manual • That all wireless access points are using the same SSID, Channel, WEP authentication mode, if any, and encryption (WPA is not available in bridge mode). • That each Point-to-Point AP has the Multi-Point AP MAC address in its Remote AP MAC address table. • That the Multi Point-to-Point AP has the MAC addresses of each Point-to-Point AP. • If Access Control has been enabled on the APs, verify that the Available Wireless Stations list (MAC Address List, Figure 3-9) for each AP is complete and accurate. 3. Verify connectivity across the LANs: • That wireless clients are able to use the AP. • A computer on any LAN segment should be able to connect to the Internet or share files and printers with any other PCs or servers connected to any of the three LAN segments. • If Access Control Lists are enabled on the APs, only computers in the access control list will be able to use the AP. Note: You can extend multi-point bridging by adding a total of six WN802T v2 APs configured in bridge mode to connect additional wireless LAN segments. Configuring Repeater without Wireless Client Association In this mode, the WN802T v2 will operate as a Repeater only, and send all traffic to the remote wireless access point. You must enter the MAC (physical) address of the remote wireless access point. Advanced Wireless Bridging 5-5 v1.0, September 2008