Onkyo TX-DS838 Owner Manual - Page 14

Connecting video equipment The TX-DS838 is equipped with an IPM system, which automatically turns on the receiver's power 3 to 5 seconds after the TV is turned on, and turns off the receiver's power 5 seconds after the TV is turned off. To use this function, connect the TV or monitor to the VIDEO-3 INPUT connectors as shown in the illustration below. 0 0 VIDEO-3 IPM ON OFF (TV) (DVD) m V VIDEO IN AUDIO OUT VIDEO OUT TV/monitor NOTE: • The IPM function does not operate if the TV/monitor screen is blank (i.e. no picture appears) after the TV is turned on or before it is turned off. • If the TV goes off, "•" flashes on the left side of the TX-DS838's display and five minutes later it also turns off. S-VIDEO connectors I ain D 0 0 0 0 00 , cal:= cal:= or= To the S-VIDEO input terminal of a TV/monitor ► To the S-VIDEO input terminal of a VCR To the S-VIDEO output terminal of a VCR To the S-VIDEO output terminal of a VDP To the S-VIDEO output terminal of a DVD or TV To the S-VIDEO output terminal of a VCR To the S-VIDEO input terminal of a VCR S Input Video Video signal flow TX-DS838 S Priority Output Video Video and S-VIDEO input and output priority A signal fed into the S-VIDEO input connector will be output to the MONITOR OUTPUT from both the S-VIDEO and the normal video connectors. However, a signal fed into the normal video connector will be output only from the normal video connector. NOTE: • When video equipment or a TV/monitor with an S-VIDEO input is connected to both the S-VIDEO output connector and the normal video output connector, some models automatically select recording or playback via the S-VIDEO connec tion (S-VIDEO connector input has priority). 14