Onkyo TX-DS838 Owner Manual - Page 28
Calibrating, speaker, levels
View all Onkyo TX-DS838 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Setting up the speaker systems Calibrating the speaker levels: 4.01, 1-1C-Se,C1 ** Sys,em Se,up A ** Speaker Setup p Speaker DSstance p ever. CaT lbsasion 11 ONKYO * T,eve Calibration * ESC Ssasting - he 'lest. Sign 0.1•TNE.Sr•=1. Calibration lit = 1 ESC Left Love . - 7d3 pb Center Level- -5d3 PP r -evel =-"_ 2c1 ) On-screen display operation 1. Move the cursor to Level Calibration in the System Setup A screen, and then press the PP' cursor button on the remote control to display the Level Calibration screen. 2. Move the cursor to Starting the Test Signal, and then press the IP. cursor button. The test signal sounds from the left front speaker. 3. Press the • cursor button on the remote control to select a speaker. r With each press of the button, the selected speaker changes one at a time in the following sequence: Left Level Center Level --> Right Level -R-Sur. Level SW Level < L Sur. Level < 4. Press the -AI or Pow cursor button to adjust the level. The adjustments can be made in 1 dB steps between -12 dB and +12 dB for all speakers. While making the adjustments, the test signal will automatically turn itself off if an adjustment is not made within 2 minutes. 5. Repeat steps 3. and 4. to adjust all speaker levels until the test signal level sounds the same from all speakers. 6. To turn off the test signal, move the cursor over and press the ENTER button. * Refer to the operations below when using just the remote control or the main unit to carry out the on-screen display operation described above. Remote control operation Main unit operation 1. Press CTESDT to sound the test signal. 2. Press c, s„ to select a speaker. 3. Press or to adjust the level. 4. Repeat steps 2. and 3. to adjust all speaker levels until the test signal level sounds the same from all speakers. 1. Press (c=) to select Test Signal. 2. Press C=I1 or (I= to select ON. The test signal sounds from the left front speaker. 3. Press to select a speaker. With each press of the button, the selected speaker changes one at a time in the following sequence: Left -> Center - Right ->R-Surround -L-Surround Subwoofer < 4. Press Co) or (C)) to adjust the level. 5. Repeat steps 3. and 4. to adjust all speaker levels until the test signal level sounds the same from all speakers. 6. After all parameters have been set, press =1) 28