Onkyo TX-RZ50 9.2-Channel THX Certified AV Receiver Instruction Manual - Engli - Page 111

• For ZONE 3 output, audio from externally connected AV components can be output only when it is an analog audio signal. • DSD audio signals cannot be output to ZONE 3 with the "NET" input selector. • If ZONE 3 is on, power consumption during standby will increase. • If ZONE 3 is turned on when the Pure Audio listening mode is selected in the main room, the mode will automatically switch to the Direct listening mode. • This function turns off if you use "Transmitting audio from this unit to BLUETOOTH wireless technology enabled devices" ( →p81). To disable the function: While pressing and holding the ZONE 3 SHIFT button on the remote controller, press . WHOLE HOUSE MODE: When the WHOLE HOUSE MODE button of the main unit is pressed during playback in the main room, "Z2" and "Z3" on the display light up at the same time, and the WHOLE HOUSE MODE function is turned on with which the same source is played back at once in all rooms. • Sources that can be played in ZONE 2 can be played in all rooms. • In the following cases, this function cannot be used. -- When headphones are connected -- When audio is output from the speakers of the TV -- When "2. Speaker" - "Configuration" - "Zone 2 Preout" on the Setup menu is set to "Zone B" ( →p132) • Depending on the setting of "2. Speaker" - "Configuration" ( →p131) in the Setup menu, it may not be able to output to ZONE 3. Playback 111