Onkyo TX-RZ50 9.2-Channel THX Certified AV Receiver Instruction Manual - Engli - Page 163
Measuring with AccuEQ Room Calibration, SETUP MIC
View all Onkyo TX-RZ50 9.2-Channel THX Certified AV Receiver manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 163 highlights
Measuring with AccuEQ Room Calibration Place the supplied speaker setup microphone at the listening position. The unit automatically measures the test tones output from each speaker, and sets the optimum volume level for each speaker, the crossover frequencies, and the distance from the listening position. This also reduces the effect of the standing wave in accordance with the viewing environment and automatically adjusts the equalizers for the speakers, and enables correction of sound distortion caused by the acoustic environment of the room. • It takes between 3 and 12 minutes for calibration to be completed. 1. Select "Exit Dirac Live & use AccuEQ" in the "Dirac Live" screen, then press ENTER. 2. Connect the supplied Speaker Setup microphone to the SETUP MIC jack on the main unit. SETUP MIC Setup • When it cannot be resolved by performing the re-measurement, confirm if the speakers are connected correctly. If there is any problem with the speaker connection, perform the connection after disconnecting the power cord. 6. Once the measurement is completed, it is possible to perform the measurement in 8 additional listening positions. To perform the measurement, select "Next" and press ENTER, then follow the instructions. To not perform the measurement, select "Finish (Calculate)" and press ENTER. • After each listening position is detected, select "Finish (Calculate)" and press ENTER to complete the detection process. 7. Disconnect the speaker setup microphone. When placing the speaker setup microphone on a tripod, refer to the illustration. 3. Confirm a test tone is output from the subwoofer and press ENTER. 4. Press ENTER to output test tones from each speaker, and the connected speakers and the noise in the surrounding environment are automatically measured. 5. The measurement results in step 4 are displayed. If there is no problem in the detection result of the speaker, select "Next" and press ENTER to output the test tone again to automatically set the settings such as volume level, crossover frequency, etc., to their optimum. (The test tone is automatically output when 10 seconds has elapsed without any operation.) • When an error message is displayed or when the connected speakers cannot be detected, perform re-measurement by selecting "Retry" and pressing ENTER. 163