Onkyo TX-RZ50 9.2-Channel THX Certified AV Receiver Instruction Manual - Engli - Page 138

3. Audio Adjust „„1. Multiplex/Mono Change the settings of multiplex audio playback. ‰‰Multiplex Input Channel (Default Value: Main) Set the audio channel or language to be output when playing multiplex audio or multilingual broadcasts, etc. • For multiplex audio broadcasts, pressing the button on the remote controller will display "1+1" on the main unit's display. Main Sub Main / Sub Main channel only Sub channel only Main and sub channels will be output at the same time. ‰‰Mono Input Channel (Default Value: Left + Right) Set the input channel when playing back analog or 2 ch PCM signals in the Mono listening mode. Left Right Left + Right Left channel only Right channel only Left and right channels ‰‰Mono Output Speaker (Default Value: Center) Set the speaker to output monaural audio in the Mono listening mode. • If an item cannot be selected even though connection is correct, check that the settings in "2. Speaker" - "Configuration" - "Speaker Channels" matches the number of connected channels. Center Left / Right Audio is output from the center speaker. Audio is output from the front L/R speakers. Setup „„2. Dolby Change the setting of when Dolby signals are input. ‰‰Loudness Management (Default Value: On) When playing Dolby TrueHD, enable the dialog normalization function which keeps the volume of dialog at a certain level. Note that when this setting is Off, the Late Night function that allows you to enjoy surround at low volumes is fixed to off when playing Dolby Digital Plus/Dolby TrueHD. On When this function is used Off When this function is not used ‰‰Center Spread (Default Value: Off) Adjust the width of the front sound field created when playing back with the Dolby Audio - Surr listening mode. • Depending on the speaker settings, "Off" is applied. On The sound field is spread to left and right. Off The sound field is centralized. 138