Onkyo TX-SV919 Owner Manual - Page 13

4. Speaker connections Connecting the speakers If you want to use Surround effects, the Surround and Center speakers must be connected. (Surround effects can be heard even if a center speaker is not connected.) The speakers that are to be located in the room as the TX-SV919THX should be connected to the A or B speaker terminals. To get the full effects of the Surround processor, ensure the Left and Right and UR Surround speakers are not reversed. Front R(B) Front R(A) Front L(A) Front L(B) FRONT AKERS A R L FRONT SPEAKERS B CAUTION SPEAKER IMPEDANCE 6 OHMS MIN /SPEAKER SURROUND SPEAKERS A RROUND SPEAKERS Center(A) Center(B) 0 O CENTER SPEAKER-A -, 1CENTER SPEAKER-B 0 0 Surround R(A) Surround R(B) Surround L(B) Surround L(A) NOTE* • Do not connect a single speaker in parallel to the front UR, center, and surround UR channel output. • Use speaker cables that have a low impedance and that are as short as possible. • SPEAKER IMPEDANCE: FRONT UR,CENTER,SURROUND UR: 6 ohms min. / speaker Connecting the speaker cables 8 mm remove insulation r D,= twist copper strands together O unscrew insert here O tighten NOTES: • When using banana plugs, make sure the speaker terminal screws are screwed in firmly before inserting the banana plugs. • Speaker terminals on European models not banana plug compat- ible. 13