Onkyo TX-SV919 Owner Manual - Page 23

Operating the remote control 1. Set the USE/LEARN selector switch to USE. USE LEARN EEO 2. Set the A/B/C (SUB ROOM) selector switch to the desired position. Then operate the remote control by pressing the key of the functions you want to use. A B C (SUB ROO, • There is no power switch for the remote control, as power is supplied automatically when a button is pressed. If no button is pressed for a short interval, power goes off automatically, to avoid wasting the battery. • If you press a button for which no code has been memorized, the LEARNED/SENDING indicator will not light up. • Please check whether previously memorized functions are working properly. If the SENDING indicator is not illuminated when a programmed button is pressed, it may need to be relearned from your existing remote control. Changing commands 1. Set the USE/LEARN selector switch to LEARN. I SI I I XRN 2. Commands should be memorized using the method outlined in the section "Learning" new controller codes. • Entering new codes for certain keys does not affect the functions of the other memorized keys. How to reset the RC-267M (Clearing memorized commands) 1. Set the USE/LEARN selector switch to LEARN. IJS, I EAR, 5. Use the tip of a pointed instrument, such as a ball- point pen, to press the Reset switch (indicated by the RESET in the battery case), then release the switch when the PRESS MATCHING KEYS indicator vas out. The reset operation is completed. 2. Switch A/B/C (SUB ROOM) selector switch to A or B you want to reset. A B C (SLUR ROOM , "RESET" switch 3. Remove the battery compartment cover. 6. Repeat step 4 to 5 to reset other keys if desired. 7. Attach the battery compartment cover again. • If there are preset ONKYO codes, the preset codes will be recalled. 4. Press the key you want to delete to light up PRESS MATCHING KEYS indicator. 23