Panasonic 50LCX63 Multi-media Display - Page 27

Basic Operation ECALL Power ON / OFF First Time Setup For your convenience, First Time Set up menu will be displayed on screen when the set is turned on for the first time. If needed, follow the menus and procedures displayed on-screen for setting up the features. POWER SAP LIGHT TV VCR DVD DBS RCVR TV/VIDEO CBL AUX A - ANTENNA - B ASPECT E BBE R CH MUT VOL OK VOL MENU CH EXIT 1 2 3 4 5 7 R-TUNE PIP MIN REW 8 0 PLAY 6 9 PROG PIP MAX FF PAUSE STOP REC FREEZE TV/VCR PIP CH SEARCH DVD/VCR CH OPEN/CLOSE PIP SPLIT MOVE SWAP Input Setup To select the configuration of RF input depending on the signal source. Note: No video will be displayed in this setup mode. First time setup Input Setup Setting Auto Scan Cable/Antenna SELECT CHANGE MENU to return OK EXIT Procedure Press VOL ► to select Cable only, Cable/Antenna, or Antenna only. Press OK to underline your selection. When the next screen is displayed, press OK to start the Auto Scan. All available channels with a signal will be programmed into memory. Auto Scan This feature allows you to selectively auto scan channels. You can Scan All, Analog only channels, or Analog & Digital channels. First time setup Input Setup Auto Scan Scan All Antenna (A) Analog Antenna (A) Analog & Digital Antenna (B) Analog Antenna (B) Analog & Digital SELECT MENU to return OK EXIT Procedure Press OK to start Auto Scan. After Auto Scan is completed the unit tunes to the first channel found during auto scan. Notes: • If DCM (Digital Cable Module) is present during the First Time Setup and Antenna (A) is set to cable, Antenna (A) will not be scanned due to the DCM providing the channel map. • If setup is incomplete, check connection of Antenna/Cable to the RF IN Terminal, then try Auto Scan again. (PP. 30-31) Notes: • Auto scan must be done when you select the input signal for the first time or whenever you change the antenna configuration. • Depending on conditions, Auto scan may take a while. 27