Panasonic AG-HMR10 Operating Instructions - Page 27

Preparation Tally lamp The tally lamp turns on during recording (red). Also, the tally lamp flashes in the following circumstances. (flashes 4 times per second) • Recording error has occurred • Battery has run out • SD Memory Card is full • System frequency has been changed (flashes once per second) • Remaining battery capacity is low • Remaining memory of the SD Memory Card is low • Setup menu has been initialized (Page 30) ■ When the AG-HCK10G camera head (optional) is connected The tally lamp flashes in the following circumstances. (flashes 4 times per second) • Cooling fan is not operating correctly • Internal temperature of the camera is abnormally high • Recording signal is corrupted • Optical Image Stabilizer is not operating correctly • Problem with the focus function • Camera cable is disconnected Tally lamp REC/ PAUSE REC/ PAUSE AUDIO MON/ADV SD Memory Card access lamp The SD Memory Card access lamp lights as follows depending on the access condition of the SD Memory Card in the portable recorder. ■ REC mode, PB mode Illuminated orange: Reading/writing possible Flashing orange (fast): Verifying card/inspecting card for possible defects Flashing orange (slow): Accessing card (recording, playing back or loading) Off: No card inserted/unformatted or incompatible card inserted ■ PC mode Flashing orange (slow): Accessing card Off: A status other than accessing SD Memory Card access lamp • Do not perform any of the following operations while the SD Memory Card access lamp is flashing. Performing these operations may damage the SD Memory Card or its contents, or cause the portable recorder to fail to operate correctly. · Removing the SD Memory Card · Switching off the power · Removing the battery · Connecting or disconnecting the USB connection cable · Shaking or striking the recorder 27