Panasonic AG-HMR10 Operating Instructions - Page 42

Using the [USER] button (continued) ■ LCD DTL (Emphasizing outlines) Emphasizing the outlines of the images you see on the LCD makes it easier to focus. Emphasizing the outlines does not affect the images you record. When this is set, the "LCD DTL ON" message is displayed in the middle of the screen. (CAM mode only) Press the [USER] button again to cancel. • This function is not canceled even when the power is turned off. • When the [USER] button is used to switch between performing and canceling this function, the [LCD DTL] setting in the [DISPLAY SETUP] setup menu is also switched. ■ LCD REVERSE (Reversing image display) While the [USER] button is pressed, viewing angles and video images can be verified by reversing the images displayed on the LCD monitor horizontally and vertically. The recorded images are not affected when the images are reversed on the screen. • The normal display is shown when the [USER] button is not pressed. ■ INDEX (Index function) This function allows you to add an index at a certain point of a clip during recording. Press the [USER] button during recording or shooting. "INDEX" is displayed on the screen and an index signal is recorded at that point. • To add an index during playback, select [INDEX] → [YES] from the [OPERATION] setup menu. (Pages 64, 91) • If an index cannot be added, "INVALID" is displayed. • Added indexes can be deleted in PB mode. (Page 64) • Up to 100 indexes can be recorded for one clip. • When the number of indexes exceeds 100, "INVALID" is displayed, and no further indexes can be added even when the steps for adding indexes are taken. • When repeatedly adding indexes, leave a gap of at least one second between adding one index and the next. If indexes are added with a gap of less than one second between them, only the first operation will be valid. ■ SHOT MARK (Shot mark function) The marks added to clip thumbnails are called shot marks. In the thumbnail screen, only clips with a shot mark can be selected for display or playback. Press the [USER] button during recording or shooting. "MARK ON" is displayed on the LCD monitor screen and a shot mark is set for the thumbnail of the clip being recorded. Press the button again to cancel. You can also set or cancel shot marks in the thumbnail screen of PB mode. However, note that you cannot set or cancel shot marks during playback. • If shot marks cannot be set or canceled, "INVALID" is displayed. ■ LAST CLIP (Last clip delete function) Deletes the last clip that was recorded or shot. When the [USER] button is pressed during recording or shooting standby, the "DELETE LAST CLIP?" message is displayed on the LCD monitor screen. Select [YES] to delete the last clip that was recorded or shot. If you do not want to delete the clip, select [NO]. • If one of the following operations is performed after finishing recording or shooting, the last clip cannot be deleted even if the [USER] button is pressed. • Mode is changed to PB mode • Recording format is changed • Portable recorder's power is turned off and back on again • SD Memory Card is removed 42