Panasonic AJSD755 AJSD755 User Guide - Page 11

Parts and their functions Display panel 1 525 WIDE dB dB 0 0 -4 -4 -8 -8 -12 -12 -16 -16 -20 -20 -25 -25 -30 -30 - - LR LR 2 3 45 7 6 8 REMOTE VIDEO CUE dB Y PB PR CMPST -8 SDI -12 SDTI/1394 -16 SG 1 2 -20 -25 CTL -30 TC - L R UB AUDIO SCH SERVO = ANALOG U AES/EBU EDIT REC INH USER SET DVCPRO SDI SDTI/1394 SG DVCAM 1 WIDE lamp This lamp lights when 16:9 wide-screen information is being recorded on a tape. Recording of wide-screen information can be selected on setup menu No. 645 (WIDE SELECT). This lights lamps during tape playback when widescreen information has been recorded on the tape. 2 REMOTE lamp This lamp lights when the CONTROL switch has been set to the REMOTE position. 3 INPUT SELECT display area The characters corresponding to the selected input signals light. With all input signals except for analog audio signals, the fact that no signals have been selected is indicated by a flashing display. VIDEO Y PB PR : Analog component video signals CMPST : Analog composite video signals SDI : Serial digital video signals (option) SDTI/1394 : Compressed digital signals (option) SG/SG 1/SG 2: Internal reference signals AUDIO ANALOG AES/EBU USER SET SDI SDTI/1394 SG : Analog audio signals : Digital audio signals : Recording audio signal selection : Serial digital audio signals (option) : Compressed digital signals (option) : Internal reference signals 4 U lamp This lamp lights when UMID information is present on the input signal in E-E mode. This lamp lights during tape playback when UMID information has been recorded on the tape. 5 SCH lamp This lamp lights when the SCH phase of the external synchronized signal (REF VIDEO) is inside the prescribed range. At all other times, the lamp is off. 6 = lamp This lamp lights when a cassette tape is inserted into the VTR. In the standby OFF mode, this lamp is flashing. 7 SERVO lamp This lamp lights when the drum servo or capstan servo locks. 8 Channel condition lamps These lamps light to indicate the error rate status. (green 5 white 5 red) Green: This lights when the error rates for the video and audio playback signals are both at acceptable levels. White : This lights when the error rate for the video or audio playback level has increased. The playback picture and sound remain unaffected even while this lamp is lighted. Red : This lights when the error rate for the video or audio playback level has increased to the extent that correction or interpolation was performed. 11