Panasonic AJSD755 AJSD755 User Guide - Page 64

Error messages $ Displaying the "HOURS METER" information Turn the search dial to move the cursor (2). The description for the item where the cursor is located is shown on the counter display. If "T&S&M" is selected in the setup menu No. 008 (DISPLAY SEL), a message appears in the mode display whenever a warning or error occurs. When multiple events occur, the event with the highest priority is displayed. No./Item Description Ser Displays the unit's serial No. 222222222 H00 OPERATION Displays the time that the power has been supplied in one-hour units. H01 DRUM RUN Displays the time that the drum has been rotating in one-hour units. H02 TAPE RUN Displays the time that the tape has been running during FF, REW, PLAY, SEARCH (JOG, SLOW, SHTL), REC, and EDIT modes (except for STILL in the JOG, SLOW or SHTL mode) in one-hour units. H03 THREADING The number of times for threading (loading)/ unthreading (unloading) is displayed in single units. H04 F LOADING Displays the number of times front loading has been performed in single units. H11 DRUM RUNr Displays the time that the drum has been rotating in one-hour units. (Can be reset) H12 TAPE RUNr Displays the time that the tape has been running during FF, REW, PLAY, SEARCH (JOG, SLOW, SHTL), REC, and EDIT modes (except for STILL in the JOG, SLOW or SHTL mode) in one-hour units. (Can be reset) H13 THREADINGr The number of times for threading (loading)/ unthreading (unloading) is displayed in single units. (Can be reset) H14 F LOADINGr Displays the number of times front loading has been performed in single units. (Can be reset) H30 POWER ON The number of times the power has been turned on is displayed in single units. OThe resettable items in the "HOURS METER" information are reset by the shop when performing maintenance or other work. OThe search buttons and the search dial cannot be operated while the DIAG menu is displayed. Priority Display/Description High Low Error messages (See error message table) When an operational malfunction has occurred in the unit, the error number flashes and the error message is indicated on the counter display. INT SG When SG has been selected as the input signal with the INPUT SELECT buttons, pressing the REC button or the EDIT button (E-E mode) will display "INT SG" for the first two seconds. This is also displayed for the first two seconds when starting editing. NO INPUT If there is no input signal (except for analog audio) to the connector selected using the INPUT SELECT buttons, pressing the REC button or the EDIT button (E-E mode) will display "NO INPUT" for the first two seconds. This is also displayed for the first two seconds when starting editing. Warning messages (See error message table) When a warning occurs in this unit, the error number and warning message are indicated on the counter display. When multiple warnings occur, the warning with the highest priority is displayed. $ UMID information display This is displayed when UMID information is present on the input signal in E-E mode. This lamp lights during tape playback when UMID information has been recorded on the tape. "NO-INFO" is displayed when there is no UMID information. Item MATNO COPY OWNR POS DTAE TIME Display/Description Material number Instance number (No. of copies) Country, organization, user Reception status from GPS satellites when recording spatial coordinates (height above sea level, longitude and latitude): HOLD: No reception from any satellite 2D: Reception possible, but number of satellites is insufficient. Height above sea level will not be accurate. 3D: Good reception Date UTC (Coordinated Universal Time) and time difference with UTC 64