Panasonic WJHD316 WJHD309 User Guide - Page 100

I [Event] Function for Events Perform the settings for event actions of each event type (motion detection, video loss, command alarm and terminal alarm). SETUP MENU Maintenance Switcher Recording Display Event Comm Event Setup VMD Setup Alarm Setup Terminal Setup I VMD I Video Loss I Terminal/Command Alarm Schedule System SETUP SETUP SETUP LIVE The following are available for the buzzer sound duration. When OFF is selected, a buzzer will not sound. (s: second, m: minute) OFF: The buzzer will not sound. 1 s - 30 s (in 1 second intervals) /40 s/50 s/1 m/2 m/3 m/4 m/5 m EXT: The buzzer will continue until the ALARM RESET button is pressed. G [Event Setup] Settings for the alarm output duration and the buzzer duration Perform the settings for the alarm output duration and the buzzer sound duration for each event type (motion detection, video loss, command alarm and terminal alarm). SETUP MENU Maintenance Switcher Recording Display Event Comm Event Setup VMD Setup Alarm Setup Terminal Setup I VMD I Video Loss I Terminal/Command Alarm Schedule System SETUP SETUP SETUP LIVE G [VMD Setup] Perform the settings for the motion detection function Select ON or OFF to determine whether to enable or disable the motion detection function for each camera channel. When ON is selected, perform the settings for the motion detection area for each camera channel. Up to 4 areas can be set for a camera channel for the detection area. Refer to page 45 for further information about the motion detection function. SETUP MENU Maintenance Switcher Recording Display Event Setup VMD Setup Alarm Setup Terminal Setup I CAM1 I CAM2 I CAM3 I CAM4 I CAM5 I CAM6 I CAM7 I CAM8 I CAM9 I CAM10 I CAM11 I CAM12 I CAM13 I CAM14 I CAM15 I CAM16 Event Comm Schedule System ON OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF LIVE SETUP MENU Maintenance Switcher Recording Display Event Comm Schedule System Event Setup VMD Setup Alarm Setup Terminal Setup I VMD I Video Loss Setup I Terminal/Command Alarm Setup I Alarm Output 10s I Buzzer 10s SETUP SETUP SETUP LIVE O K CANCEL The following are available for the alarm output duration. When OFF is selected, the alarm output will not be supplied. (s: second, m: minute) OFF: No alarm output is supplied. 1 s - 30 s (in 1 second intervals) /40 s/50 s/1 m/2 m/3 m/4 m/5 m EXT: Alarm output will continue until the ALARM RESET button is pressed. Important: The alarm output duration cannot be set for video loss. Signals will be supplied continuously from the camera error output terminal (pin no. 17) of the ALARM/CONTROL connector on the rear panel during the period when the video signal is lost. (Refer to page 83.) [Screenshot 1] Start operation from the camera channel selection menu of the "VMD Setup" window. SETUP MENU Maintenance Switcher Recording Display Event Setup VMD Setup Alarm Setup Terminal Setup I CAM1 I CAM2 I CAM3 I CAM4 I CAM5 I CAM6 I CAM7 I CAM8 I CAM9 I CAM10 I CAM11 I CAM12 I CAM13 I CAM14 I CAM15 I CAM16 Event Comm Schedule System ON OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF LIVE z Rotate the jog dial to select ON for a desired camera channel for which the motion detection function is to be applied, and press the SET button. 100