Panasonic WJHD316 WJHD309 User Guide - Page 34
to a point to be determined as the end point of, Move the cross cursor using the arrows button
View all Panasonic WJHD316 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
MONITOR1 MONITOR2 R 123 4 STOP PLAY PAUSE REC - REC STOP REV FWD R PAN/ GOTO TILT LAST SEARCH SHIFT SEQ OSD PAN/TILT SETUP 567 8 ZOOM/ A-B SLOW /ESC FOCUS REPEAT - + DISK SELECT COPY TEXT MARK 9 10/0 11 12 IRIS LISTED 1 EL-ZOOM LOGOUT LOGOUT PRESET /AUTO 2 13 14 15 16 SET BUSY m.⁄0 m ,⁄1 m Move the cross cursor using the arrows button to a point to be determined as the end point of the motion detection area. ⁄0 Select the sensitivity using the arrows button (D C) from the following. OFF: Motion will not be detected LOW: Low sensitivity MID: Standard sensitivity 3H16IGH: High sensitivity ⁄1 Rotate the jog dial to select "EXIT" on the sta- tus bar to exit from the motion detection area setup window. Press the SET button to determine the selected point as the end point of the motion detection area. It is possible to set up to 4 motion detection areas by repeating steps 6 and 7. , Rotate the jog dial to select "SENSITIVITY" on the status bar. Note: Depending on the position of the set detection areas, the sensitivity indications of the detection areas may be displayed overlapping each other. . Move the cross cursor to the motion detection area to apply the sensitivity using the arrows button (A B). 34