Panasonic WV-ST165 Operating Instructions - Page 141
Con the settings relating to the alarm output terminal [Alarm]
![]() |
View all Panasonic WV-ST165 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 141 highlights
13 Configure the alarm settings [Alarm] H.264 recording (SD memory card) [Pre alarm] Determine whether or not to perform the pre alarm recording. When "Use" is selected, 1 MB image data is always saved during the pre alarm recording. Use/ Not use • Default: Not use [Post alarm (recording) duration] Set the duration to save image data on the SD memory card after an alarm occurrence. 10s/ 20s/ 30s/ 40s/ 50s/ 60s/ 120s/ 180s/ 240s/ 300s • Default: 30s * The actual recording time may sometimes be longer than the duration selected for this setting. [Recording (memory) size per an alarm] The capacity of the SD memory card used to record video data upon an alarm occurrence. The actual capacity may be different. IMPORTANT • To record H.264 data, it is required to select "Use" for "SD memory card" on the [SD memory card] tab. In addition, it is required to select "H.264" for "Recording format". (®page 58) 13.5 Configure the settings relating to the alarm output terminal [Alarm] Click the [Alarm] tab on the "Alarm" page. (®page 47, page 49) The settings relating to the alarm output terminal can be configured in this section. Alarm output terminal setup [Alarm output trigger] Select "On" or "Off" to determine whether or not to output the alarm signals to the alarm output terminal when an alarm is detected. • Default: Off [Alarm output type] Select "Latch" or "Pulse" for the alarm output terminal at an alarm occurrence. • Latch: When an alarm is detected, the alarm output terminal will be in the state selected for "Trigger output" until the alarm occurrence indication button is clicked. Operating Instructions 141
![](/manual_guide/products/panasonic-wvst165-operating-instructions-6b72a96/141.png)