Pioneer DEH-80PRS Owner's Manual - Page 25
Using subwoofer output - standard mode
View all Pioneer DEH-80PRS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Operating this unit Section 02 Operating this unit 2 Turn LEVER to select the speaker unit (filter) to be adjusted. Low LPF (low-range speaker LPF)-Mid HPF (middle-range speaker HPF)-Mid LPF (middle-range speaker LPF)-HighHPF (high-range speaker HPF) 3 Press /DISP to display the upper tier. 4 Use M.C. to select NW 2. Refer to Introduction of audio adjustments on page 20. 5 Turn M.C. to select the cut-off frequency (crossover frequency) of the selected speaker unit (filter). Low LPF: 25-31.5-40-50-63-80-100 -125-160-200-250 (Hz) Mid HPF: 25-31.5-40-50-63-80-100 -125-160-200-250 (Hz) Mid LPF: 1.25k-1.6k-2k-2.5k-3.15k- 4k-5k-6.3k-8k-10k-12.5k (Hz) HighHPF: 1.25k-1.6k-2k-2.5k-3.15k- 4k-5k-6.3k-8k-10k-12.5k (Hz) 6 Turn LEVER to adjust the level of the selected speaker unit (filter). ±0dB to -24dB is displayed as the level is increased or decreased. +6dB to -24dB is displayed as the level is increased or decreased, only if you have selected Low LPF. 7 Press /DISP to display the upper tier. 8 Use M.C. to select NW 3. Refer to Introduction of audio adjustments on page 20. 9 Turn LEVER to select the slope of the selected speaker unit (filter). Low LPF: -36- -30- -24- -18- -12 (dB/ oct.) Mid HPF: -24- -18- -12- -6-Pass (0) (dB/oct.) Mid LPF: -24- -18- -12- -6-Pass (0) (dB/oct.) HighHPF: -24- -18- -12- -6 (dB/oct.) 10 Press M.C. to switch the phase of the selected speaker unit (filter). NOR (normal)-REV (reverse) # You can adjust the parameters for other speaker units (filters) in the same way. 11 Press /DISP to display the upper tier. 12 Use M.C. to select NW 4. Refer to Introduction of audio adjustments on page 20. 13 Press M.C. to select stereo or monaural. Stereo (stereo)-MONO (monaural) # You can operate this procedure only when Low LPF is selected. 14 Press BAND/ to cancel the network adjustment mode. Using subwoofer output This unit is equipped with a subwoofer output which can be turned on or off. When a sub- woofer is connected to this unit, turn the sub- woofer output on. The subwoofer output phase can be switched between normal and reverse. ! This function is only available in standard mode . 1 Use M.C. to select SW 1. Refer to Introduction of audio adjustments on page 20. 2 Press M.C. to turn subwoofer output on. ON appears in the display. Subwoofer output is now on. # To turn subwoofer output off, press M.C. again. 3 Turn LEVER to select stereo or monaural. Stereo (stereo)-MONO (monaural) En 25