Ricoh CL7200DT2 Setup Guide - Page 110
ble from the duplex reversal unit to the upper connector on the back
UPC - 026649024139
View all Ricoh CL7200DT2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
Installing Options E Hang the auxiliary bar on the far left end, as shown, and then install the stopper removed in step B. Make sure the auxiliary bar and stopper are installed in the positions, as shown. F Slowly raise the duplex reversal unit, and then fold it up to the printer. G Remove the adhesive tape holdings the cable, and then connect the ca- ble from the duplex reversal unit to the upper connector on the back of the printer. This completes installation of the duplex reversal unit. Install the duplex feed unit after the external tray. 110
Installing Options
110
E
Hang the auxiliary bar on the far left end, as shown, and then install the
stopper removed in step
B
.
Make sure the auxiliary bar and stopper are installed in the positions, as
shown.
F
Slowly raise the duplex reversal unit, and then fold it up to the printer.
G
Remove the adhesive tape holdings the cable, and then connect the ca-
ble from the duplex reversal unit to the upper connector on the back of
the printer.
This completes installation of the duplex reversal unit. Install the duplex feed
unit after the external tray.