Ricoh CL7200DT2 Setup Guide - Page 92
unit slot.
UPC - 026649024139
View all Ricoh CL7200DT2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
Installing Options • Antenna Cap B Turn off the power then unplug the power cable, and then interface ca- ble. C Slowly open the front cover of the printer, remove the green screwdriv- er, and then close the cover. p.54 "Using the Screwdriver" D Remove the screws by turning them counterclockwise using the provid- ed screwdriver, and then remove the cover of the Bluetooth interface unit slot. E Insert the interface unit until it stops, and then secure it by tightening its two screws. F Check the Bluetooth interface unit is connected firmly to the controller board. 92
Installing Options
92
•
Antenna Cap
B
Turn off the power then unplug the power cable, and then interface ca-
ble.
C
Slowly open the front cover of the printer, remove the green screwdriv-
er, and then close the cover.
p.54 “
Using the Screwdriver
”
D
Remove the screws by turning them counterclockwise using the provid-
ed screwdriver, and then remove the cover of the Bluetooth interface
unit slot.
E
Insert the interface unit until it stops, and then secure it by tightening its
two screws.
F
Check the Bluetooth interface unit is connected firmly to the controller
board.