Ricoh CL7200DT2 Setup Guide - Page 82
Tighten the four screws fastening the controller board back into its orig
UPC - 026649024139
View all Ricoh CL7200DT2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Installing Options I Connect the power cable and flat cable to the controller board. J Align the controller board with the top and bottom rails, and then push it in using the port marked "PUSH" until it stops. K Tighten the four screws fastening the controller board back into its orig- inal position, using the provided screwdriver. The printer hard disk automatically begins formatting when the printer is switched on. ❒ Be sure to return the provided screwdriver to its original position on the in- side of the front cover. 82
Installing Options
82
I
Connect the power cable and flat cable to the controller board.
J
Align the controller board with the top and bottom rails, and then push
it in using the port marked “PUSH” until it stops.
K
Tighten the four screws fastening the controller board back into its orig-
inal position, using the provided screwdriver.
The printer hard disk automatically begins formatting when the printer is
switched on.
❒
Be sure to return the provided screwdriver to its original position on the in-
side of the front cover.