Ricoh CL7200DT2 Setup Guide - Page 80
printer, using the provided screwdriver.
UPC - 026649024139
View all Ricoh CL7200DT2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Installing Options B Turn off the power then unplug the power cable, and then interface ca- ble. C Slowly open the front cover of the printer, and remove the green screw- driver, and then close the cover. p.54 "Using the Screwdriver" D Remove the four screws fastening the controller board to the back of the printer, using the provided screwdriver. The removed screws will be used later to fasten the controller board. E Holding the handle, slowly pull out the controller board. Put the controller board down on a flat surface. 80
Installing Options
80
B
Turn off the power then unplug the power cable, and then interface ca-
ble.
C
Slowly open the front cover of the printer, and remove the green screw-
driver, and then close the cover.
p.54 “
Using the Screwdriver
”
D
Remove the four screws fastening the controller board to the back of the
printer, using the provided screwdriver.
The removed screws will be used later to fasten the controller board.
E
Holding the handle, slowly pull out the controller board.
Put the controller board down on a flat surface.