Samsung MZ-5PA128B User Manual - Page 69
When the backup begins, the command file is run during the specified stage. If
View all Samsung MZ-5PA128B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Backing up entire drives 69 Defining a drive-based backup You can specify the location of command files if you want them to be located in a place other than the default location. You can also specify a location on a per-job basis, as well as specify a location that can be shared among several computers. If you specify a network location, you will be asked for network credentials. The most common use for running command files is to stop and restart non-VSS-aware databases that you want to back up. To use a Visual Basic script file (.VBS) during a backup, you can create a batch file (.BAT) to run the script. For example, you can create a batch file called STOP.BAT that contains the following syntax: Cscript script_filename.vbs Make sure that Cscript precedes the file name of the Visual Basic script. Warning: The command files cannot depend on any user interaction or have a visible user interface. You should test all command files independently of Norton Ghost before you use them during a backup. When the backup begins, the command file is run during the specified stage. If an error occurs while a command file is running or the command file does not finish in the time you specified (regardless of the stage), the backup is stopped, the command file is terminated (if necessary), and the error information is logged and displayed. The following table describes the stages of recovery point creation.