Sharp AR-P450 AR-P350 AR-P450 Operation Manual - Page 68
Misfeed in the paper feed area, MISFEED REMOVAL
View all Sharp AR-P450 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
MISFEED REMOVAL Misfeed in the paper feed area NOTE Be sure to follow the misfeed removal sequence. Do not pull the paper tray out first as paper may be located between the paper tray and the paper feed section. If the tray is pulled first, the misfed paper may be torn and difficult to remove. The following procedure shows the removal sequence when the machine is equipped with a duplex module. If the machine is not equipped with a duplex module or any output device, the procedure is basically the same.The left side of the machine must be opened and cleared before the paper tray is pulled out. s Misfeed in paper tray 1 1 Unlatch the duplex module and slide it to the left. Unlatch the module and gently move the module away from the machine. If the machine is not equipped with a duplex module, open the side cover similarly. 5 Gently close the duplex module. If the machine is not equipped with a duplex module, close the side cover. After closing, confirm that the misfeed message has been cleared and the normal display appears. 2 Remove the misfed paper. Be careful not to tear the misfed paper during removal. NOTE If paper drops beyond the rear side of the paper tray that has been pulled out, remove the paper tray and then remove the paper. (For removal of the paper tray, see the illustration below.) NOTE The paper may not be extending out far from inside the machine but must be removed if it is possible to grasp it. If it is not possible to grasp it, go to the next step. 3 If misfed paper is not found in step 2, pull out paper tray 1 and remove the misfed paper. Be careful not to tear the misfed paper during removal. 4 Gently close the paper tray. Push the paper tray back into the machine. After pulling out the paper tray until it stops, gently lift and pull the tray to remove it. To reinstall the paper tray, insert it at an angle and then push it into the machine. To remove a paper tray from a stand/paper drawer, pull the tray out until it stops then rotate it to the left to disengage it from the stand. When reinstalling it, place the left rear or the drawer into the slot and rotate the drawer to the right and into the stand. Installation of trays in the stand/3x500 sheet paper drawer The middle and lower trays cannot be installed in the upper tray position and the upper tray cannot be installed to the middle and lower tray positions. (These cannot be pushed into the machine.) Take care not to install a tray to an improper position after removing the tray. 4-4