Sharp MX-C301W Operation Guide - Page 667

SYSTEM SETTINGS Image Send Settings Settings related to the image send function (scan, Internet fax, etc.) can be configured. Touch the [Image Send Settings] key to configure the settings. For explanations of settings related to the fax function, see "SYSTEM SETTINGS FOR FAX" (page 7-103). Operation Settings The operation settings below apply to all image send functions. Other Settings Default Display Settings You can select one of 5 base screen types for the base screen that appears when the [IMAGE SEND] key is touched or when the [CLEAR ALL] ( ) key is pressed in image send mode. • Address Book • Scan • Internet Fax • Fax • Data Entry Hold settings for a while after scanning has been completed Use this setting to hold the settings after scanning is completed (until Auto Clear Mode activates). Address Book Default Selection One of the following screens can be specified for the initial address book screen. Tab Switch • ABC • Group Address Type • All • E-mail • FTP/Desktop • Network Folder • Internet Fax (Including Direct SMTP) • Fax • Group Preview Setting These settings are for previewing received data. The settings are "Received Data Image Check Setting" and "Default List/Thumbnail Display". These two settings are the same as "Received Data Image Check Setting" and "Default List/Thumbnail Display" in the operation settings, and the selections made here are applied to those settings. Initial Resolution Setting The following settings are available for the default resolutions of scan, Internet fax, and fax mode. Scan : 100X100 dpi, 200X200 dpi, 300X300 dpi, 400X400 dpi, 600X600 dpi Internet fax : 200X100 dpi 200X200 dpi 200X400 dpi 400X400 dpi Half Tone 600X600 dpi Fax: Standard Fine Super Fine Half Tone Ultra Fine Apply the Resolution Set when Stored When an image stored by document filing is used, this applies the resolution setting that was stored with the image. Image Orientation Sets the default image orientation. 7-80 Contents