Sharp PN-V701 PN-V701 Operation Manual - Page 35

Menu Items nZOOM2 SPECIAL SETTING If you connect a laptop computer with any of the following screen resolutions and black bands appear around the screen, set ZOOM2 SPECIAL SETTING of INPUT SIGNAL on the SCREEN menu to ON and then select ZOOM2 in the SIZE setting. This displays the area inside the black band. Laptop computer Corresponding signal*1 resolution 1280x800 1280x1024, 1280x960, 1400x1050*2 1280x600 1280x720 1024x600 1024x768 *1: This setting is effective only when the screen resolution, including the black band, is one of the resolutions listed above. *2: Use the automatic screen adjustment. nSCHEDULE You can set the time to switch the monitor on and off. Set this function with SCHEDULE in the SETUP menu. (See page 28.) SCHEDULE D-SUB[RGB] (2) (3) No. (1) POWER DAY OF THE WEEK (4) (5) (6) TIME INPUT BRIGHT - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - OK:[ENTER] CANCEL:[RETURN] 1. Press the or button to select the SCHEDULE number, and press the button. 2. Set the SCHEDULE. (See the description below.) Press the or button to select items, and press the or button to change the setting. 3. Press the ENTER button. SCHEDULE becomes effective. (1) ●: SCHEDULE effective -: SCHEDULE not effective (2) POWER ON : Switches the monitor on at the specified time. OFF : Switches the monitor off at the specified time and puts the monitor in standby mode. (3) DAY OF THE WEEK Specifies the day of the week to execute the SCHEDULE. 0:ONLY ONCE Executes the SCHEDULE once on the specified day. Specify the day of the week to execute the SCHEDULE. 1:EVERY WEEK Executes the SCHEDULE on the specified day of the week every week. Specify the day of the week to execute the SCHEDULE. Periodic setting such as "Monday through Friday" is also possible. 2:EVERY DAY Executes the SCHEDULE every day regardless of the day of the week. (4) TIME Specifies the time to execute the SCHEDULE. Set the time on a 12-hour basis. (Factory default) Can be entered as 24-hour time using the TIME setting in DATE/TIME FORMAT. (5) INPUT Specifies the input mode at power-on. If you don't specify this the input active at the last power-off will appear. When START INPUT MODE is set to a value other than LAST INPUT MODE, the input mode configured for START INPUT MODE will be set. Input modes displayed on D-SUB will depend upon the INPUT SELECT settings. (6) BRIGHT Sets the brightness when changing the screen brightness at a specified time. Caution • Do not switch off the main power after setting the SCHEDULE. • Specify the correct date and time. (See page 28.) SCHEDULE does not function unless the date and time are specified. • Check regularly that the set date and time are correct. • When a temperature abnormality occurs and the backlight brightness is reduced, the brightness is not changed even if a schedule set to BRIGHT is executed. TIPS • Up to 8 SCHEDULE items can be registered. • Setting the SCHEDULE flashes the power LED alternately in red and orange in standby mode. • A SCHEDULE that has a large number has precedence over that of a small number when schedules overlap. 35 E