Sony BRC-X400 Operating Instructions - Page 20
Connecting the camera to a PoE, Power over Ethernet Plus power, supply device
View all Sony BRC-X400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
2 Fix the cord of an AC adapter with the cord clamper so that it does not come out. Unlock the cord clamper and put the cord through it. AC adapter cord clamper Unlock the cord Cord clamper lock clamper lock. Network cable (commercially available) AC adapter cord Put the AC adapter cord through the cord clamper and lock the cord clamper. Note Do not use any AC adapter other than the supplied AC adapter. Otherwise, a fire or malfunction may occur. Connecting the camera to a PoE+ (Power over Ethernet Plus) power supply device A PoE+ (IEEE802.3at compliant) power supply device supplies power through a commercially available network cable. For details, see the operating instructions of the power supply device. Hub with PoE+ power supply feature Notes • When you supply power from a PoE+ power source, use a network cable of Category 5e or higher. • When both the AC adapter and PoE+ power supply are connected, power is supplied through the AC adapter. • When power is supplied from PoE+, both the POWER lamp (green) and NETWORK lamp (green) flash until the initial verification process is complete (approximately 1 minute, depending on the power supply device). • When the network camera is powered by a PoE+ power supply, do not route the wiring outdoors. • If a non PoE+ compatible device is connected, both the POWER lamp (green) and NETWORK lamp (green) flash, and the camera won't start. • When you turn the power off, wait at least 10 seconds before you turn it on again. • Use an STP (shielded) network cable. 20