Sony BRC-X400 Operating Instructions - Page 29
Storing the Camera Settings in Memory – Preset Feature, Preset Feature
View all Sony BRC-X400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Storing the Camera Settings in Memory- Preset Feature Settings, including the camera position, zoom, focus, and backlighting, can be stored in a preset. You can also store presets from the Administrator menu on a web browser. For details, see "Preset position tab" (page 89). Notes The camera supports up to 256 presets. The number of presets that are supported will vary depending on the device used. - For the RM-IP500 (sold separately), up to 100. - For the RM-IP10 (sold separately), up to 16. - For the remote commander (supplied), up to 6. - For a web browser, up to 256 positions. For details on the camera settings that can be preset, see "Preset Items and Image Setting File Items" (page 96). Storing the camera status 1 Press the PAN-TILT RESET button to reset the pan/ tilt position. 2 Adjust the position, zoom, and focus of the camera (See pages 28 and 28). 3 Hold down the PRESET button and press any of the POSITION buttons, 1 to 6, in which you want to store the settings. While holding down Press the POSITION button you want to set. Note Before you store the position, zoom, focus, etc. of the camera, make sure to install and secure the camera in place to use it properly. Recalling the stored status Press any of the POSITION 1 to 6 buttons in which you have stored the settings. Clearing the preset memory Hold down the RESET button and press the desired POSITION button 1 to 6 for which you want to clear the settings. While holding down Press the POSITION button you want to clear. Notes • If you want to retain the previous pan and tilt positions when the power is turned off and turned on again, store those positions in PRESET 1. • Storing or clearing the settings in PRESET 1 takes about 2 seconds longer than for other preset operations. • When you are storing or clearing the settings in one PRESET, you cannot restore, store or clear the settings in another PRESET. • For details on the items that can be cleared from the memory, see "Preset Items and Image Setting File Items" (page 96). • When [PRESET MODE] is set to [MODE2] in the SYSTEM menu, only the pan/tilt, zoom, and focus positions of the camera are recalled (BRC-X400/X401). • You can register or delete the preset even while the menu is being displayed. However, you cannot perform the pan/tilt operation. • When [PRESET MODE] is set to [TRACE] in the SYSTEM menu, the PTZ trace function works (BRC-X400/X401). For details, see "Storing Camera Pan/Tilt and Zoom Operations - PTZ TRACE function (BRC-X400/X401)" (page 30). • Note that if you change the image flip setting, the set preset will be cleared. 29