Sony BRC-X400 Operating Instructions - Page 42
OPTICAL FILTER, IR CUT FILTER Day/Night ICR - mode
View all Sony BRC-X400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
FLICKER CANCEL (Picture - Flicker cancel) When this is turned [ON], the flicker correction feature becomes enabled. When this is turned [OFF], the flicker correction feature becomes disabled. Note Depending on conditions such as the type of illumination and shutter speed, the flicker correction feature may not be effective. If the frame rate is close to the power supply frequency, the flicker correction feature may not be able to fully remove flickers, even if it is enabled. If this happens, use the electronic shutter. We recommend to set [FLICKER CANCEL] to [OFF] under lights where no flicker is generated, such as outdoors. IMAGE STABILIZER (Picture - Image stabilizer) You can select this function according to the shooting conditions. [OFF]: The image stabilization feature becomes disabled. [ON]: The image stabilization feature becomes enabled. When set to [ON], you can obtain steadier images if vibration is present. Notes • The image stabilizer function is not effective during pan/tilt operations. It may take some time for the image to stabilize after performing pan/tilt operations. • If the image stabilizer function is already enabled, it may take some time for the image to stabilize after turning on the power of the camera. • Depending on the installation conditions, the image stabilizer may not be effective. OPTICAL FILTER IR CUT FILTER (Day/Night ICR - mode) You can choose either to enable or disable the IR cut filter feature. By disabling the IR cut filter feature, the gain in the IR region is increased allowing the camera to capture images in shadow. [DAY]: IR cut filter feature is enabled to remove unnecessary IR. [NIGHT]: IR cut filter feature is disabled. The picture becomes monochrome. [AUTO]: The mode is automatically switched to [DAY] or [NIGHT]. Note When this setting is set to [AUTO], set [EXPOSURE MODE] to [FULL AUTO]. ICR THRESHOLD (Day/Night ICR - Switching level) When [IR CUT FILTER] is set to [AUTO], choose a level to switch from [NIGHT] to [DAY] in the range from 0 to 255. The mode is subject to change from [NIGHT] to [DAY] the smaller the chosen value is. Note If the larger value is chosen, the mode may not be switched to the DAY mode even when the object is bright. In this case, choose the smaller value. 42