Sony BRC-X400 Operating Instructions - Page 74
Knee BRC-X400/X401, Picture, 3D NR level PICTURE - 3D NR LEVEL
View all Sony BRC-X400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Black gamma range (GAMMA - BLACK GAMMA RANGE) You can adjust the brightness range that black gamma works. Select from [Low], [Middle], and [High]. The brightness range becomes narrow when you select [Low], and it becomes large when you select [High]. Black level (GAMMA - BLACK LEVEL) You can adjust the master black level. Select a value from [-48] to [0] to [+48]. Knee (BRC-X400/X401) Knee setting (KNEE - SETTING) Select the checkbox to set the Knee. Knee mode (KNEE - KNEE MODE) When you select [Auto], the knee level is automatically optimized based on the brightness level of the video being shot. When you select [Manual], you can manually adjust the knee level irrespective of the brightness level of the video being shot. This setting is available when the checkbox of [Knee setting] is selected. Knee slope (KNEE - KNEE SLOPE) When [Knee mode] is set to [Manual], you can adjust the gradient of knee (compression rate). Select a value from [-7] to [0] to [+7]. This setting is available when the checkbox of [Knee setting] is selected and [Knee mode] is set to [Manual]. Knee point (KNEE - KNEE POINT) When [Knee mode] is set to [Manual], you can adjust the knee point. Select a value from [0] to [12]. This setting is available when the checkbox of [Knee setting] is selected and [Knee mode] is set to [Manual]. Picture High resolution mode (PICTURE - HIGH RESOLUTION) Select the checkbox to emphasize edges for higherresolution images. Notes • When you select the checkbox, image noise may increase. • When [Mode] is set to [Manual] in [Detail], the function is not available. NR mode (PICTURE - NOISE REDUCTION) Select the noise reduction setting. [Simple]: Set the noise reduction strength of 2D/3D at the same level and removes noise simultaneously. [Advanced]: Set the noise reduction strength of 2D/ 3D individually and removes noise simultaneously. NR (XDNR) This setting is available when [NR mode] is set to [Simple]. Select from Off (minimum) or level [1] through level [5] (maximum) for noise reduction. 2D NR level (PICTURE - 2D NR LEVEL) This setting is available when [NR mode] is set to [Advanced]. Select from [0] to [5] for noise reduction. 3D NR level (PICTURE - 3D NR LEVEL) This setting is available when [NR mode] is set to [Advanced]. Select from [0] to [5] for noise reduction. Image stabilizer (PICTURE - IMAGE STABILIZER) Select the checkbox to display steadier images when the camera is installed in a place subject to vibration. Notes • When the Image stabilizer function is set, the angle of view of the image will be smaller than usual. • Depending on the vibration frequency, Image stabilizer may not work even when it is set. • Select the checkbox of [Image stabilizer] when installing the camera. Flicker cancel (PICTURE - FLICKER CANCEL) When you select the checkbox, the flicker correction feature is enabled. Note Depending on conditions such as the type of illumination and shutter speed, the flicker correction feature may not be effective. If the shooting frame rate is close to the power supply frequency, the flicker correction feature may not be able to fully remove flickers even when it is enabled. If this happens, adjust the shutter speed. We recommend you to clear the checkbox of [Flicker cancel] when shooting under lights where no flicker is generated, such as outdoors. 74