Sony DCR-TRV80 Operating Instructions - Page 79
Dubbing only desired scenes - Digital program editing on tape, Step 2: Setting the VCR to operate
View all Sony DCR-TRV80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Editing Dubbing only desired scenes - Digital program editing (on tape) Step 2: Setting the VCR to operate To connect using the A/V connecting cable, send the control signal by infrared rays to the remote sensor on the VCR. The POWER switch should be set to . Operate by touching the panel. (1) Turn the power of the connected VCR on. If the VCR has an input selector, set it to input mode. When you connect a video camera recorder, set its power switch to VCR/ VTR. (2) Press FN to display PAGE1. (3) Press MENU to display the menu. (4) Select VIDEO EDIT in , then press EXEC (p. 182). (5) Select TAPE, then press EXEC. (6) Press EDIT SET. (7) Select CONTROL, then press EXEC. (8) When connecting with the A/V connecting cable, select IR, then press EXEC. When connecting with the i.LINK cable, select i.LINK, press EXEC, then go to "Step 3: Adjusting the synchronization of the VCR" on page 82. (9) Select IR SETUP, then press EXEC. (10) Select the IR SETUP code of your VCR, then press EXEC. Check the code in "About the IR SETUP code" (p. 81). 4 OTHERS DATA CODE BEEP COMMANDER D I SPL AY V I DEO ED I T EXIT RETURN TAPE MEMORY EXEC RET. 5 V I DEO ED I T 0:32:30:14 MARK START ED I T UNDO I N SET TOTAL 0:00:00:00 SCENE 0 END 6 V I DEO ED I T END ED I T SET CONTROL I R ADJ TEST "CUT - I N" "CUT -OUT" I R SETUP PAUSEMODE I R TEST EXEC RET. 7 V I DEO ED I T END ED I T SET CONTROL I R ADJ TEST i. L I NK "CUT - I N" "CUT -OUT" I R SETUP PAUSEMODE I R TEST EXEC RET. 9 V I DEO ED I T END ED I T SET CONTROL ADJ TEST "CUT - I N" "CUT -OUT" I R SETUP 3 PAUSEMODE I R TEST EXEC RET. 79