Sony SRG360SHE Product Manual Operation Manual SRG-360SHE - Page 16

Installation and Connection Installing the Camera Installing the Camera on a Desk Place the camera on a flat surface. If you have to place the camera on an inclined surface, make sure that the inclination is less than ±15 degrees to guarantee pan/tilt performance, and take measures to prevent it from falling. Notes • Do not grasp the camera head when carrying the camera. • Do not turn the camera head by hand. Doing so may result in a camera malfunction. Attaching the Camera to a Tripod Attach a tripod to the screw hole used for attaching a tripod on the bottom of the camera. The tripod must be set up on a flat surface and its screws tightened firmly by hand. Use a tripod with screws of the following specifications. 4 = 4.5 - 7 mm 4 = 3/16 - 9/32 inches Caution Installation of the camera using the tripod screws and screw holes should not be done for installation on a ceiling or a shelf, etc., in a high position. Installing the Camera Using the M3 Fixing Screw Holes Attach the camera using 4 M3 fixing screw holes located on the bottom of the camera. Attach the camera to a fitting with a flat surface using M3 screws with the following specifications. M3 screw 4 = 3 - 8 mm 4 = 1/8 - 11/32 inches Installing the unit on the ceiling Using the ceiling bracket, wire rope, and screws supplied, you can attach the camera to the ceiling. When you install the unit, always install it on a level ceiling. If you have to install it on a sloping or uneven ceiling, make sure that the place where you install it is within ±15 degrees of the horizontal. CAUTION • Entrust installation to an experienced contractor or installer when installing the unit on ceilings or other high locations. • When installing the unit in a high location, be sure that the location and installation components (excluding the supplied accessories) are strong enough to support the unit and the mounting bracket, and install the unit securely. If the components are not strong enough, the unit may fall and cause serious injury. • Always install the supplied wire rope to prevent the unit from falling. • If you install the unit in a high location, check periodically, at least once a year, to ensure that the connection has not loosened. If conditions warrant, make this periodic check more frequently. Before installation Determine the shooting direction of the camera, and then make the holes for the ceiling bracket (B) and the connecting cables on the ceiling. Notes • The connecting cables cannot be passed through ceiling bracket (B). A hole for the wiring is required in the ceiling at the back of the unit where it is attached to the ceiling. • The recommended tightening torque for each screw are described in below. M3: 0.6 N·m (6.1 kgf·cm) M2.6: 0.4 N·m (4.1 kgf·cm) 16