Sony STR-DN1030 Operating Instructions (Large File - 11.51 MB) - Page 118
Tuner, there is no sound output from the TV. - 6 ohm speaker
View all Sony STR-DN1030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
Recording cannot be carried out. • Check that the equipment is connected correctly. • Select the source equipment using the input buttons (page 50). • Audio input signals via HDMI IN and DIGITAL IN jacks cannot be recorded. • Copyright protection to prevent recording is contained in the sources. In this case, you may not be able to record from the sources. A test tone is not output from the speakers • The speaker cords may not be connected securely. Check to see if they are connected securely and cannot be disconnected by pulling on them slightly. • The speaker cords may have short-circuit problem. • Make sure that you are not using PARTY STREAMING function (page 74). A test tone is output from a different speaker than the speaker displayed on the TV screen • The speaker pattern set up is incorrect. Make sure that the speaker connections and the speaker pattern match correctly. When the receiver is in standby mode, there is no sound output from the TV. • When the receiver enters into standby mode, sound is from the last HDMI equipment selection before you turned off the receiver. If you are enjoying other equipment, play the equipment and perform the One-Touch Play operation, or turn on the receiver to select the HDMI equipment you want to enjoy. • Make sure "Pass Through" is set to "ON" in the HDMI Settings menu if you connect equipment not compatible with the "BRAVIA" Sync to the receiver (page 98). There is a time gap between the audio output and visual display. • Check that the PARTY STREAMING function is not being used. To close a PARTY, press SHIFT, then hold down PARTY until "CLOSE PARTY" appears. For details, see page 74. Tuner The FM reception is poor. • Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antennas (aerial) as shown below. Outdoor FM antenna (aerial) Receiver Radio stations cannot be tuned in. • Check that the antennas (aerials) are connected securely. Adjust the antennas (aerials) and connect an external antenna (aerial), if necessary. • The signal strength of the stations is too weak with automatic tuning. Use direct tuning. • Make sure you set the tuning scale correctly (when tuning in AM stations with direct tuning) (page 59). • No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations is used). Preset the stations (page 60). • Press AMP, then press DISPLAY repeatedly on the remote control so that the frequency appears on the display panel. 118US