Sony VPL-VW11HT Operating Instructions - Page 27
The SET SETTING Menu, STATUS on-screen display, INPUT-A, LANGUAGE, POWER SAVING, SIRCS RECEIVER
View all Sony VPL-VW11HT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
The SET SETTING Menu The SET SETTING menu is used for changing the settings of the projector. SET SETTING INPUT-A STATUS: ON INPUT-A: COMPONENT INPUT-B: COMPONENT LANGUAGE: ENGLISH POWER SAVING: OFF SIRCS RECEIVER: FRONT&REAR CINE MOTION: AUTO STATUS (on-screen display) Sets up the on-screen display. ON: Shows all of the on-screen displays. OFF: Turns off the on-screen displays except for the menus, a message when turning off the power, and warning messages. INPUT-A Selects the computer, component, DTV YPBPR or DTV GBR signal input from the INPUT A connectors. Note If the setting is not correct, "Please check INPUT-A setting." appears on the screen and the color of the picture becomes strange or the picture is not displayed. INPUT-B Selects the computer, component, DTV YPBPR or DTV GBR signal input from the INPUT-B connectors. Notes • If the setting is not correct, "Please check INPUT-B setting." appears on the screen and the color of the picture becomes strange or the picture is not displayed. • Set the progressive component signal, e.g. DVD, to "COMPONENT"; 15k RGB signal, e.g. game machines, to "DTV GBR." The SET SETTING Menu The signals that can be output for each setting of INPUT-A and -B are as shown below. Signal Setting of INPUT -A and -B COMPUTER COMPONENT DTV YPBPR DTV GBR 15k RGB - (DVD output in PAL system, etc.) - - Component - - Progressive - - Component (Progressive DVD output etc.) DTV (Digital BS - - output, etc.) Computer - - - : can be output - : cannot be output LANGUAGE Selects the language used in the menu and on-screen displays. Available languages are: English, French, German, Italian, Spanish, Japanese and Chinese. POWER SAVING When set to ON, the projector goes into the power saving mode if no signal is input for 10 minutes. The power saving mode is canceled when a signal is input or any key is pressed. SIRCS RECEIVER Selects the remote control detectors (SIRCS receiver) on the front and rear of the projector. FRONT & REAR: Activates both the front and rear detectors. FRONT: Activates the front detector only. REAR: Activates the rear detector only. CINE MOTION Selects either position according to the signal source for the NTSC3.58/4.43, 15k RGB (60 Hz) or 525/60 signal. AUTO: Set to AUTO when the input signal is from a film-originated material. 2-3 pull down is applied. OFF: 2-3 pull down is not applied. Note This function will not operate for signals of 50Hz. 27 (GB)