Stihl FS 360 C-EM Instruction Manual - Page 26

English N Pull the guard washer (1) and thrust plate (2) off the shaft. N Thoroughly clean the guard ring, shaft, thrust plate and guard washer - do not remove the guard ring. Blocking the Shaft 1 2 3 2 The output shaft (1) must be blocked with the stop pin (2) to mount or remove cutting attachments. The stop pin is included with the machine and is available as a special accessory. N Insert the stop pin (2) in the bore (3) in the gearbox as far as stop, apply slight pressure. N Rotate shaft or cutting attachment until the stop pin slips into position and blocks the shaft. Mounting the cutting attachment. WARNING Use a deflector that matches the cutting attachment - see "Mounting the Deflector". 0812BA021 KN 002BA385 KN Fitting Mowing Head with Screw Mounting Keep the instruction leaflet for the mowing head in a safe place. 1 N Screw the mowing head counterclockwise on to the shaft (1) as far as stop. N Block the shaft. N Tighten down the mowing head firmly. NOTICE Remove the tool used to block the shaft. Removing the Mowing Head N Block the shaft. N Unscrew the mowing head clockwise. Removing and Installing Metal Cutting Attachment Keep the leaflet and packaging of the metal cutting attachment in a safe place. WARNING Wear protective gloves to reduce the risk of direct contact with the sharp cutting edges. Mount only one metal cutting attachment. Mounting Grass Cutting Blades, Brush Knife Note on new machines that come standard with a mowing head only: A "metal mowing attachment mounting kit" is required to mount a grass cutting blade or brush knife. Kits are available from your servicing dealer. 24 FS 260 C, FS 360 C