Stihl FS 360 C-EM Instruction Manual - Page 40
Engine Running Behavior
View all Stihl FS 360 C-EM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
English N Check electrode gap (A) and readjust if necessary - see "Specifications". N Use only resistor type spark plugs of the approved range. Rectify problems which have caused fouling of spark plug: N Too much oil in fuel mix. N Dirty air filter. N Unfavorable running conditions, e.g. operating at part load. Fit a new spark plug after approx. 100 operating hours or earlier if the electrodes are badly eroded. detachable SAE adapter nut, it must be attached.) A loose connection between spark plug boot and ignition wire connector in the boot may create arcing that could ignite combustible fumes and cause a fire. Installing the Spark Plug N Screw the spark plug into the cylinder. N Press the spark plug boot firmly onto the spark plug. 4 3 2 Engine Running Behavior If engine running behavior is still unsatisfactory after the air filter has been serviced and the carburetor and throttle cable have been adjusted correctly, the cause may also be in the muffler. Have the muffler checked for contamination (coking) by a servicing dealer! STIHL recommends that maintenance and repair work be carried out only by authorized STIHL dealers. N Fit the cap (1) on the shroud from the rear and push the lug (2) into the opening (3) in the shroud at the same time. N Swing the cap forwards onto the 1 shroud, insert and tighten down the screw (4) firmly. 000BA036 TR 9926BA022 KN WARNING To reduce the risk of fire and burn injury, use only spark plugs authorized by STIHL. Always press spark plug boot (2) snugly onto spark plug terminal (1) of the proper size. (Note: If terminal has 38 FS 260 C, FS 360 C