Stihl TS 410 Instruction Manual - Page 33

370BA071 KN Assembling the Cast Arm and Guard The "cast arm with guard" is mounted on the inboard side by the manufacturer. The "cast arm with guard" can also be mounted on the outboard side depending on requirements. Assembly on the inboard side is recommended for freehand cutting on account of the better balance. Outboard mounting N Disassemble the cutting wheel (see "Fitting / replacing an cutting wheel") Removing the water attachment 3 1 2 1 N Unscrew the banjo bolt (1) with the combination wrench - in the process, remove the square nut from the inside of the guard from the guide N Remove the water hose (2) with connector from the adjusting lever (3) N Pull the water hose (2) out of the guide (arrows) in the V-belt guard 370BA068 KN Removing the adjusting lever 3 2 1 N Unscrew the banjo bolt (1) with the combination wrench and remove it together with the seal - in the process, remove the square nut from the inside of the guard from the guide N Remove the screw (2) N Turn the adjusting lever (3) upwards and remove Slackening the V-belt 2 1 0 1 1 N Loosen the nuts (1) - do not remove them N Turn the tensioning nut (2) counterclockwise with the combination wrench - approx. 1/4 turn, as far as it will go = 0 370BA070 KN 370BA069 KN Removing the V-belt guard English 2 1 N Loosen the screw (1) - it is secured on the V-belt guard (2) to prevent loss N Raise the V-belt guard (2) slightly and pull it off to the front 4 3 N Remove the V-belt (3) from the front pulley (4) 370BA079 KN TS 410, TS 420 31