Stihl TS 410 Instruction Manual - Page 34

English Removing the "cast arm with guard" 3 21 1 1 N Remove the nuts (1) N Remove the "starter cover with rewind starter" (2) N Remove the "cast arm with guard" (3) from the studs Preparing the "cast arm with guard" for outboard mounting 1 N Unscrew stop pin (1) 370BA073 KN 370BA072 KN 370BA074 KN A 1 45 32 N Turn the guard so that it is in the position shown (see picture) N Screw in and tighten the stop pin (1) N Move the adjusting lever (2) to position A N Screw in the bolt (3) and tighten up N Remove screw (4) from the limit stop (5) N Pull off the limit stop (5) N Insert the square nut into the guide in the guard and hold it in place N Screw in the shorter banjo bolt (6) and washer at the adjusting lever and tighten up with the combination wrench Mounting "cast arm with guard" - guard on the outboard side 12 12 12 6 43 370BA075 KN 45 N Turn the "cast arm with guard" so that the guard is on the outboard side N Insert limit stop (5) - align the hole in the limit stop with the hole in the cast arm N Screw in the bolt (4) and tighten up N Press the oblong holes (1) in the "cast arm with guard" on to the studs (2), guiding the ribbed V-belt over the front pulley NOTICE The belt action must run smoothly. N The belt tensioner (3) must sit close to the lug (4) 370BA008 KN 32 TS 410, TS 420