Stihl TS 410 Instruction Manual - Page 35

2 2 2 56 6 6 N Fit the "starter cover with rewind starter" (5) over the studs (2) N Tighten up the nuts (6) by hand 370BA051 KN N Fit the support with the longer banjo bolt on the adjusting lever (3) - screw in the banjo bolt and tighten with the combination wrench N Insert the water hose into the guide in the V-belt guard (arrow) from the water connection towards the guard - avoid tight radiuses Checking the adjustment range of the guard Inboard mounting English N Disassemble the cutting wheel (see "Fitting / replacing an cutting wheel") N Remove water attachment N Remove the adjusting lever N Slacken the V-belt N Remove the V-belt guard N Remove the "cast arm with guard" Preparing the "cast arm with guard" for inboard mounting 7 370BA077 KN 8 N Push the V-belt guard (7) into place N Screw in the bolt (8) and tighten up Connecting water connection 3 1 2 1 N Insert the longer banjo bolt (1) through the connector (2) of the water attachment - observe the position of the connector N Insert the square nut into the guide in the guard and hold it in place 370BA078 KN A N Rotate the guard forwards and backwards as far as possible - adjustment range (A) must be limited by the stop pin Continue as described in the chapter "Tensioning the V-belt." TS 410, TS 420 370BA076 KN 12 N Remove the screw (1) of the limit stop (2) N Pull off the limit stop (2) 3 12 N Turn the "cast arm with guard" so that the guard is on the inboard side N Insert limit stop (2) - align the hole in the limit stop with the hole in the cast arm 33 370BA081 KN 370BA080 KN