Symantec 10521146 Administration Guide - Page 116

116 Protection policies Using protection policies by configuring a protection policy with blocking enabled. You can enable blocking only on in-line interface pairs on a 7100 Series node. To make sure that blocking is enabled at the event list level, see also "Enabling or disabling blocking rules" on page 123. To enable or disable blocking on in-line interfaces 1 In the Policies > Protection Policies tab, in the right pane, click an in-line pair. 2 Do one of the following: ■ Click Enable Blocking. ■ Click Disable Blocking. 3 Click Apply to save and apply changes. Undoing policy settings This section describes how to remove or revert the application of policies to interfaces. Unapplying protection policies The Network Security console provides a way to unapply or remove the application of protection policies from node interfaces. To unapply a protection policy assignment 1 In the Policies tab, in the right Policies Applied To Interfaces pane, right-click an interface. 2 Click Unapply Policy from the pop-up list. 3 In the Protection Policies tab, click Apply to save and apply changes. Removing policies set to interfaces The Network Security console provides an alternative to unapplying protection policies from interfaces. To remove policies from interfaces 1 In the Policies tab, click a protection policy in the left pane. 2 Click Set to Interfaces. 3 In Apply Policy to Selected Interface, click the interface or group of interfaces to remove this policy from, and click OK.