Symantec 10521146 Administration Guide - Page 255

Managing log files 255 Exporting data To configure this parameter 1 Click Configuration > Node > Network Security Parameters. 2 In Select Node, choose the node from the pull-down list, and click OK. 3 In the left pane, click under Log & Database Parameters, click Event Writer File. 4 In the lower right pane, enter a value. 5 Click Apply. 6 In Apply Changes To, select the node to which to apply the parameter. 7 Click OK to save the changes to this node and close. Note: Restart Symantec Network Security for changes to this parameter to take effect. Exporting to SESA Symantec Network Security can export event data to Symantec Enterprise Security Administrator (SESA) using the SESA Bridge Export node parameter. You can install the Bridge to both software and appliance nodes by running the Bridge installation script located in the /usr/SNS/install/sesabridge directory. The SESA Bridge enables you to send events form Symantec Network Security to the SESA management console. The Bridge is not required to use Symantec Network Security in native mode. This section describes the following topics: ■ Integrating with SESA ■ Setting SESA Bridge Export Integrating with SESA Symantec Network Security includes the capability to send security events to SESA. You cannot configure Symantec Network Security from the SESA Console. The installation procedure installs the SESA Bridge with Symantec Network Security, so all have to do is enable exporting to SESA via the SESA Bridge Export parameter. You need the following: ■ Symantec Network Security installed on a dedicated computer, or Symantec Network Security 7100 Series appliance