Symantec 10521146 Administration Guide - Page 146

146 Responding Setting response actions ■ Maximum number of SNMP notifications: Enter the number of notifications you want to send. ■ Delay between SNMP notifications (mins): Enter the time in minutes that you want Symantec Network Security to wait before sending another notification. 5 In Configure Response Action, click OK to save and exit. 6 In Response Rules, click OK to save and exit. Setting SNMP notification parameters The Network Security console provides a way to refine the SNMP notification response action by tuning the following configurable parameters: ■ SNMP Manager ■ SNMP Community String SNMP Manager SNMP Manager indicates where the software or appliance node sends SNMP traps. To configure this parameter 1 Click Configuration > Node > Network Security Parameters. 2 In Select Node, choose the node from the pull-down list, and click OK. 3 In the left pane, click SNMP Manager. 4 In the lower right pane, enter the SNMP Manager that will receive SNMP traps from the node. 5 Click Apply. 6 In Apply Changes To, select the node to which to apply the parameter. 7 Click OK to save the changes to this node and close. SNMP Community String SNMP Community String indicates the community string that Symantec Network Security uses to send traps to the SNMP Manager. To configure this parameter 1 Click Configuration > Node > Network Security Parameters. 2 In Select Node, choose the node from the pull-down list, and click OK. 3 In the left pane, click SNMP Community String.