TP-Link TL-WR840N User Guide - Page 14
The Rear Panel - 300mbps wireless router
View all TP-Link TL-WR840N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
1.4.2 The Rear Panel TL-WR840N 300Mbps Wireless N Router User Guide Figure 1-2 Rear Panel sketch The following parts are located on the rear panel (View from left to right). WIFI: This button is used to enable/disable the Router's wireless function. WPS/RESET: This button is used for both WPS and Reset function. To use the WPS function, press it for less than five seconds; to use the RESET function, press it for more than five seconds. Used as RESET button: There are two ways to reset to the Router's factory defaults: 1) Use the Factory Defaults function on System Tools -> Factory Defaults page in the Router's Web-based Utility. 2) Use the WPS/RESET button: With the Router powered on, press and hold the WPS/RESET button (more than 5 seconds) until the SYS LED becomes quick-flash from slow-flash. Then release the button and wait the Router to reboot to its factory default settings. Used as WPS button: If you have client devices, such as wireless adapters, that support Wi-Fi Protected Setup, then you can press this button to quickly establish a connection between the Router and client devices and automatically configure wireless security for your wireless network. INTERNET: This INTERNET port is where you will connect the DSL/cable Modem. 4,3,2,1 (LAN): These ports (4,3,2,1) connect the Router to the local PC(s). ON/OFF: The switch for the power. POWER: The Power socket is where you will connect the power adapter. Please use the power adapter provided with this TL-WR840N 300Mbps Wireless N Router. - 5 -