Toshiba M105-S3004 User Manual - Page 100
LAN, LAN cable types, Connecting LAN cable
UPC - 032017538498
View all Toshiba M105-S3004 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
User's Manual If you used the Task Tray icon to disable W-LAN, restart the computer or follow the procedures below to enable the system to recognize W-LAN. Open or click the following: Start, Setup, Control Panel, System, Device Manager and Renew. LAN LAN circuits support Ethernet LAN (10 megabits per second, 10BASE-T) and Fast Ethernet LAN (100 megabits per second, 100BASE-TX). This section describes how to connect/disconnect to a LAN. CAUTION: Do not install or remove an optional memory module while Wake-up on LAN is enabled. NOTE: Wake-up on LAN does not work without the AC adaptor. Leave it connected, if you are using this feature. LAN cable types CAUTION: The computer must be configured properly before connecting to a LAN. Logging onto a LAN using the computer's default settings could cause a malfunction in LAN operation. Check with your LAN administrator regarding set-up procedures. If you are using Fast Ethernet LAN (100 megabits per second, 100BASE-TX), be sure to connect with a CAT5 cable. You cannot use a CAT3 cable. If you are using Ethernet LAN (10 megabits per second, 10BASE-T), you can connect with either a CAT5 or a CAT3. Connecting LAN cable To connect the LAN cable, follow the steps below. CAUTIONS: 1. Connect the AC adaptor before connecting the LAN cable. The AC adaptor must remain connected during LAN use. If you disconnect the AC Adaptor while the computer is accessing a LAN, the system may hang up. 4-18 OPERATING BASICS