Toshiba M105-S3004 User Manual - Page 85

Changing Slim Select Bay modules 2. Position a new cap on the peg and press it into place. NOTE: The peg is square, so be careful to align the cap's square hole with the peg. Changing Slim Select Bay modules This section explains how to change modules in the Slim Select Bay. The illustrations show replacement of the DVD-ROM drive with the Slim Select Bay HDD adaptor. Therefore, the text refers to those modules. However, the procedures are the same for any of the modules: CD-RW/DVD-ROM drive, HDD adaptor, Slim Select Bay 2nd battery pack with separate tray or weight saver. CAUTIONS: 1. To avoid injury, do not put your hand into the Slim Select Bay slot. 2. Before removing or inserting a second battery pack, turn off the computer's power. NOTE: The TOSHIBA Mobile Extension is preinstalled to support hot swapping under Windows. Refer to Chapter 1, Introduction for information on using this utility to change modules while the computer's power is on. Removing a module Remove the DVD-ROM drive as described below. 1. Check all disk indicators to make sure no disks are operating. 2. Turn the computer upside down. CAUTION: Wait for all disk indicators to go out before you turn over the computer and be careful to lay the computer down gently. Shock can damage the HDD or other components. 3. Slide the Slim Select Bay latch to the unlock position. 4-3 OPERATING BASICS